Ideal Amplifier Probe and Tone Generator

$125.95
Reference#: 71062
Item#: ID-33-864



Description

Amplifier Probe
  • Designed to identify and trace wires or cables within a group without damaging the insulation
  • Battery low indicator

Tone Generator
  • Three different tones selected from front panel
  • Auto-off of tone after three hours to conserve battery life
  • F-Connector port for toning & tracing coaxial CATV cabling systems

Features

Tone Generator
Use the IDEAL tone generator (62-160) to apply a tone signal to a wire pair or single conductor, and trace with an amplifier probe (IDEAL 62-164). When used with the amplifier probe, the tone generator allows technicians to identify a wire within a bundle, at a cross connect or at a remote end.It can be used on twisted pair, coax, and de-energized AC wiring.
  • F-connector port for toning and tracing of coaxial CATV cabling systems
  • Three different tones selected from front panel
  • Tone can be added in any status – allows test sets without monitor feature to pick up tone
  • Separate Talk Battery status for increased voltage and power for test sets
  • Auto-OFF of tone after three hours to conserve battery life
  • Constant tone amplitude over life of battery
  • Two tone amplitude – normal and half
  • No power draw in continuity status with leads open
  • RJ jack allows use of modular cable or alligator clipsn
  • Low battery LED indicates when to change battery
  • 9 volt battery included

Amplifier Probe
The Amplifier Probe is designed to identify and trace wires or cables within a group without
damaging the insulation. It allows for pin point identification even in the most congested cable
bundles. Our unit can be used with any tone generator.
Features

  • Works with any Tone Generator (62-160) to identify wires
  • Volume control for increased sensitivity and adjustable to suit work environment
  • Recessed ON/OFF button prevents battery drain
  • Battery low indicator
  • 9 volt battery included

Downloads

Videos